Before First Use
1. Before use, remove all packaging and inspect the appliance for any damage. If there appears to be any
damage, please take the unit back to place of purchase for a replacement.
2. Ensure that all the accessories are included as per diagram above before you can continue with the
installation.
3. Ensure that the location of the heater installed is not directly under or in front of a power socket and that a
power socket is available to power the appliance.
4. Refer to the installation guide for further instructions.
Installation
Drill two holes on the wall allowing 1.8 meters above the floor and 20cm from side walls. Be sure to make
the hole diameter the same as the expanding screw pipe. Place the expanding screw pipe into the hole in
the wall and then fix two screws on the expanding pipe, keep the tips of the screws out 10mm, and hang up
the heater. Ensure that the screws are strong enough. Screw and screw mounts are provided.
WARNING: DO NOT MOUNT DIRECTLY UNDER OR IN FRONT OF AN ELECTRICAL POWER OUTLET.
WARNING: NOT TO BE INSTALLED IN WET AREAS.
To Next Page
Loading...
Need help?
General