• Always disconnect the plug form the wall socket when the radiator is not in use.
• Do not position the radiator immediately below a socket outlet.
• Do not leave the heater running unattended.
• Do not use the appliance other than its intended use.
• Do not immerse or expose the product or flexible cord to rain, moisture or any other liquid.
• Switch off and unplug from the outlet when the heater is not in use and before cleaning.
• Always allow the unit to cool down first before cleaning or storing it away.
• Do not immerse or expose the product or flexible cord to rain, moisture or any other liquid.
• Switch off and unplug from outlet when the product is not in use and before cleaning. Always allow the unit to cool
down first before cleaning or storing it away.
• To avoid personal injuries or property damage, do not insert any body parts (e.g. finder) or objects through the air
inlet or outlet openings when the heater is operating.
• This product is intended for normal domestic/household use only.
• Always disconnect the heater when moving it from one location to another.
• The use of attachments or accessories not recommended or sold by the product distributor may cause personal or
property hazards or injuries.
• The surfaces of the heater are very hot during operation. Avoid contact with the wind outlet. Use handles and knobs
if necessary.
• Do not twist or wrap the power cord around the appliance as this may cause the insulation to weaken and split,
particularly where it enters the unit.
• Use of an extension cord is not recommended. However, if it is necessary ensure the cord is short as possible (long
cords coiled up can overheat and cause tripping accidents).
• Do not use the appliance on the same socket or electric circuit with other electrical appliances so as to prevent the
circuit from being overloaded, which will cause fire. Please do not prolong the power cords by yourself or use
movable socket.
• Ensure the cord is fully extended before use and accommodate it so that it is not in touch with any part of the heater.
• Do not use the heater in areas such as garages where petrol or other flammable substances are used or stored. Do
not use the heater when flammable sprays, solvents and glues are in use.
• Keep combustible materials such as furniture, pillows, bedding, clothes and curtains at least 50cm from sides of
heater.
• Ensure heater is not blocked and there are spacing of at least 50cm around its sides and 120cm from the front or
heat outlet.
• Avoid touching the heater body whilst the heater is on. Do not move the appliance while it is functioning in order
to avoid overheating with the additional risk of fire.
• Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (danger of overheating).
• When the appliance is used in portable version, do not place it up against the walls, furniture, curtains, etc.
• The appliance must not be positioned directly underneath a fixed power point.
• Do not use the appliance while it is cooling down, in order to avoid overheating with the attendant risk of fire.
• Do not use the appliance in rooms less than 4m² area.
• CAUTION: Surfaces are hot during use. Please use handle or knob.
• The installation of a residual current device (safety switch) is recommended to provide additional safety protection
when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not
exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for professional
advice.
• This product must always be used AND STORED in the upright position.
• The heater must not be located immediately below a socket outlet.
COMPULSORY WARNING
This heater is filled with a precise quantity of oil. Repairs requiring the opening of the oil container are only to be conducted
by the manufacturer or a qualified service agent who should be contacted if there is an oil leakage.
Disposal of the oil should be in accordance with local regulations. You should contact your local council to determine the
correct procedure.
If the supply cord is damaged it must be replaced by the manufacturer or its service agent or a similarly qualified person to
avoid a hazard. This product has not been designed for any uses other than those specified in this booklet.
To Next Page
Loading...
Need help?
General
