OPERATION
This heater is equipped with Electronic Digital Controls that provide the ability to set the temperature to the exact degree
desired.
To operate, simply follow these instructions.
NOTE: The temperature display will not reflect the accurate room temperature until the heater has been operating for at
least 20 minutes.
1. Turn on Power Switch, Press the power button once to start the heater on High Power ( ), Continuous Run.
If left at this setting, the unit will run continuously on High Power and will not shut off until the unit is manually
turned off or the room temperature over 30℃.
2. Press the power button again to change to Middle Power ( ), Continuous Run. If left at this setting, the unit will
run continuously on Middle Power and will not shut off until the unit is manually turned off or the room
temperature over 30℃.
3. Press the power button again to change to Lower Power ( ), Continuous Run. If left at this setting, the unit will
run continuously on Lower Power and will not shut off until the unit is manually turned off or the room
temperature over 30℃.
4. Press the power button a fourth time to turn the heater OFF.
The heater will run continuously if no temperature setting is selected.
If it operated at the Low setting, the heater would not provide as much heat output as in the High Setting.
However, the Low setting will not require as much electrical current to operate. To avoid overloading a circuit, do
not plug the heater into a circuit that already has other appliances working.
Set Temperature
Press the switch button, the heater enters standby mode,
By now, if the ambient temperature was below 4 ℃, the heater can automatically start heating function.
1. Press the switch button, the heater enters standby mode, the screen blinks at 1 second interval.
To Next Page
Loading...
Need help?
General
