How to fix large ice cubes sticking together in my HELLER HIM12?
If the ice made by your HELLER Ice Maker is too large and the pieces are sticking together, this could be happening because the water temperature is too low. Try selecting the small size. Also, this could be caused by ice from a previous cycle left in the water tray, so make sure you remove the ice after each cycle.
What to do if the water shortage indicator light is on in my HELLER Ice Maker?
If the water shortage indicator light is on in your HELLER Ice Maker, it could be due to two reasons. First, there might be no water in the unit; in this case, add water until it reaches the MAX fill line. Second, the pump might be full of air; try pressing the POWER button to restart the device.
Why are all the indicator lights twinkling on my HELLER HIM12 Ice Maker, and how to fix it?
If all the indicators on your HELLER Ice Maker are twinkling simultaneously, it means that the water tray is blocked by an ice cube. To resolve this, switch the unit off, unplug the power cord, and remove the ice blocking the tray. Then, plug the power cord back in and press the POWER button; the machine will start after 3 minutes.
What to do if the indicator lights are not on on my HELLER HIM12 Ice Maker?
If the indicator lights on your HELLER Ice Maker are not on, it usually means there's a blown fuse or no power. To fix this, replace the fuse or turn the power on.
Why does my HELLER HIM12 compressor make a buzzing noise?
If the compressor in your HELLER Ice Maker is working abnormally and making a buzzing noise, it's likely that the voltage is lower than recommended. Stop using the ice maker and do not restart it until the voltage matches what is indicated on the rating plate.
Explains power, add water, ice full indicators, and select button for ice size.
Steps for adding water, plugging in, and selecting ice size for initial operation.
To Next Page
General