CONTROL PANEL OPERATION
The POWER indicator light will flash when the unit is plugged in. Once turned on the unit enters
standby mode. Press the POWER button to begin operation. If the POWER button is pressed
during operation, the machine will return to standby mode.
Press the SELECT button to choose the ice size. The default size is large ice. When you select the
desired ice size, the corresponding indicator light of S (small) or L (large) will illuminate.
When the ADD WATER indicator light is illuminated, it means there is insufficient water in the water
reservoir. More water will need to be added, and the POWER button will need to be pressed to
restart the machine.
When the ice compartment is full, the ICE FULL indicator will flash, and the machine will stop
working. The ice will need to be removed to make room for more ice.
OPERATING INSTRUCTIONS
1. Open the lid and take out the ice basket and add appropriate water into water reservoir.
NOTE: The water in the water reservoir should be lower than the MAX fill line. If the water is above the
MAX fill line, then open the water drain plug and drain excess water. Once finished close the transparent
lid.
2. Plug the power cord into a power outlet, and press the POWER button to start the machine.
3. Select the desired ice size by pressing the SELECT button (default ice size is ‘L’).
NOTE:
• Select the small ice size when ambient room temperature is below 15°C. When the ambient
temperature is higher than 30°C, large ice cubes are recommended.
• The ice may be small and irregular in size for the first three cycles.
To Next Page
Loading...
Need help?
General
