EasyManuals Logo

HELLER HPH20 User Manual

HELLER HPH20
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
PARTS LIST
8 x screws
2 x feet
4 x long screws
4 x wall plugs
Details
HPH20
Voltage
220-240Vac
Frequency
50-60Hz
Power
1000/2000W
IMPORTANT SAFEGUARDS
When using any electrically powered product, basic safety precautions should always be followed, including the
following:
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
WARNING: To avoid overheating, DO NOT COVER the heater.
This appliance is for household use only.
This appliance should only be used as intended.
Check item carefully before use. Do not switch on heater with defects or damaged cord.
DO NOT place this heater in water, near water, in wet areas and areas subject to water spray and in damp
locations.
The heater is hot when in use. To avoid burns, DO NOT touch any hot surfaces. Keep combustible materials, such
as furniture, pillows, bedding, papers, clothes, and curtains at least 3.3 ft (1 m) from the front of the heater and
keep them away from the sides and rear.
Plug only into AC source. Do not use non-standard power supply.
This appliance should be connected to the same voltage as printed on the rating label and package.
This heater must not be located immediately below a socket-outlet.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HELLER HPH20 and is the answer not in the manual?

HELLER HPH20 Specifications

General IconGeneral
BrandHELLER
ModelHPH20
CategoryHeater
LanguageEnglish

Related product manuals