HELLER HWR2400 - Before Using; Initial Setup Steps; Control Panel and Operation; Component Identification

BEFORE USING
1. Take the unit from the box. fully unwind the power cord.
2. Make sure the heater is in the OFF position before plugging into a 220-240Vac outlet.
3. Avoid using other appliances in the same outlet to overload the circuit.
4. Use the heater only on a stable and level surface.
FEATURES
CONTROL PANEL
OPERATION INSTRUCTIONS
The heater has:
- One power selection switch which selects the power.
- One adjustable thermostat which controls the temperature settings.
- One indicator which shows the heater working conditions.
THE POWER SELECTION SWITCH
Model
Rated Voltage
HWR2400
220-240Vac
600W
1200W
1800W
2400W
WARNING: To reduce the risk of electric shock, keep all connections dry and off the ground. Do not
touch plug with wet hands.