E-12
positioned correctly best reception is obtained.
AM or FM no sound
- Unit not in “RADIO” function mode.
- Volume set at minimum
- Press MODE BUTTON to select
AM or FM mode
- Increase Volume.
CD player will not play
- Unit not in CD function mode.
- CD is not loaded properly.
- If the CD is self-compiled, the
media used may not be
compatible with the player.
- Exhausted battery
- Select CD function mode.
- Load CD with label side up.
- Use better quality blank media
and retest.
- Replace the batteries.
CD skips while
playing
- Disc is dirty or scratched. - Wipe CD with clean cloth or use
another disc.
Intermittent sound
from CD player
- Dirty or defective disc
- Dirty pick up lens
- Player is subject to excessive
shock or vibration
- Clean or replace the defective
disc.
- Use a CD lens cleaning disc to
clean the lens.
- Relocate the player away from
shock or vibration.
Sound appears
distorted at high
volume setting
- Volume control is set to maximum.
- Batteries become low
- Adjust Volume Control to a lower
comfortable level.
- Replace all the old batteries with
new ones.
AUX IN no sound
- Unit not in AUX IN mode
- AUX cable connect unstable
- Press MODE BUTTON to select
AUX IN mode
- Reconnect again
Bluetooth not
operating
- Unit not in Bluetooth mode
- Bluetooth connect unstable
- Press MODE BUTTON to select
BLUETOOTH mode
- Reconnect again
SPECIFICATIONS AND LEGAL STATEMENT
Power Source : AC: 120V~ 60Hz or 6 x “C” (UM-2) batteries (not included)
Power Consumption : 10 W
Speaker Power Output : 2 X 1W RMS
Speaker Impedance : 8 ohm
Frequency Range : AM 520-1710 KHz / FM 87.5-108 MHz
The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and
any use of such marks by Spectra Merchandising International, Inc. is under license. Other
trademarks and trade names are those of their respective owners.
To Next Page
Loading...
Need help?
General
