4
EN
• Always turn the appliance off before disconnecting the plug.
• Never use accessories other than those recommended by the manufacturer. Failure to do
so could pose a safety risk to the user and could damage the appliance. Only use original
parts and accessories.
• This appliance is not intended for use by persons (including children) with reduced phys
-
ical, sensory or mental capabilities, or lack of experience and knowledge.
• This appliance must not be used by children under any circumstances.
• Keep the appliance and its cord out of reach of children.
• Always disconnect the appliance from the mains if it is left unattended or is not in use,
and before assembly, disassembly or cleaning.
• Never leave the appliance unattended during use.
Special Safety Regulations
• This appliance is only suitable for warming sausages. It is not suitable for other food.
• Danger of burns: Do not touch the appliance while in use. The appliance becomes
hot during use. Only touch the handles of the appliance.
• Always allow the appliance to cool down before cleaning.
• Only use water. Do not use oil or fat in the container.
• Risk of splashing! Slowly immerse the sausages into the water.
• Attention! Do not fill water over MAX level or below MIN level.
• Check the water level regularly. Add water if the water level below MIN level.
• Do not open the lid of the appliance while it is under operation. Heat and steam will come
out.
• Do not heat up the appliance without water. The appliance must be turned on after water
is poured into the container.
• Do not pour hot water into plastic containers. The containers may deform or even melt.
Preparations before using for the first time
• Unpack the appliance carefully and remove all
protective packaging and wrapping. Make sure
no packaging debris remains on the appliance.
• Check delivery contents for any missing parts
(bottom grid included) and any possible trans-
port damage. In the event of damage in transit or
missing parts, contact your supplier immediately.
• Place the appliance on a horizontal, stable and
heat resistant surface. Leave at least 15 cm of
space around and above the appliance for venti-
lation purposes.
• Let the appliance heat up for 10 ~ 15 minutes at
the highest temperature (85ºC) (See --> Opera-
tion) to remove all residues from the manufactur-
ing process. It may also emit some odour for the
first few cycles. This is normal and does not lead
to defect or hazard.
• Let the appliance & water cool down completely
before cleaning for further use.
To Next Page
Loading...