Hendi Profi Series - Special Safety Regulations; Operating Environment and User Precautions; Grounding Installation; Grounding Requirements

4
NL
• Never use accessories other than those recommended by the manufacturer. Failure to do
so could pose a safety risk to the user and could damage the appliance. Only use original
parts and accessories.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge.
• This appliance must not be used by children under any circumstances.
• Keep the appliance and its cord out of reach of children.
• Always disconnect the appliance from the mains if it is left unattended or is not in use,
and before assembly, disassembly or cleaning.
• Never leave the appliance unattended during use.
Special safety regulations
• This appliance should be operated on a level, horizontal, dry, stable and heat resistant
surface.
• This appliance should be operated by trained personnel.
• The user must wear close-fitting dressing during operation. Scarf is not allowed.
• Do not use the appliance to slice frozen food, meat that has not been deboned, fish or any
non-food products.
• Though the appliance has built-in safety features, keep away from the blade and moving
parts at all times.
• Stop using the appliance as soon as the blade’s diameter has become thinner than 6 mm.
Replace the blade.
Grounding installation
This appliance is classified as protection class I
and must be connected to a protective ground.
Grounding reduces the risk of electric shock by
providing an escape wire for the electric current.
This appliance is equipped with a cord having a
grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly in-
stalled and grounded.
Preparations before using for the first time
• Check to make sure no parts are missing. If any
parts are missing, contact your supplier.
• Remove all the packing material.
• Clean the appliance with lukewarm water and a
soft cloth.
• Clean the blade. Be careful: the blade is very
sharp.
• Keep open a space of at least 10 cm around the
appliance to allow for adequate ventilation.
• Position the appliance in such a way that the plug
is always accessible.
• If the sharpening device is not attached, proceed
as follows:
EN