Henkel LOCTITE EQ RC34

Questions and Answers

J
Jennifer BurnsAug 11, 2025
What to do if there is no product dispensing from my Henkel LOCTITE EQ RC34?
- J
  Joanne RayAug 11, 2025
  If no product is being dispensed from the Henkel Controller, first ensure the product reservoir is full. If it is empty, refill it. Next, confirm that the product reservoir is switched on by setting the depressurizing valve to pressurize. Finally, check if the reservoir is active by pressing the appropriate button on your controller model: for Controller 97102, press ; for Controller 97152, press ; for Controller RC15, press .
B
Briana McclainAug 17, 2025
Why am I getting too little product from my Henkel LOCTITE EQ RC34?
- S
  Stephanie BergerAug 17, 2025
  If you're getting too little product from the Henkel Controller, the dispensing pressure might be inadequate. Try increasing the dispensing pressure on the controller. Also, check the air supply pressure and increase it if it's too low. Finally, the dispensing valve may have malfunctioned and should be checked.
B
Bruce PerezAug 23, 2025
How to fix pressurized air escaping from Henkel LOCTITE EQ RC34 reservoir?
- E
  Evan AtkinsonAug 23, 2025
  If you notice pressurized air escaping between the reservoir housing and the reservoir lid of your Henkel Controller, make sure the reservoir knob is tightened. If the knob is already tight, the O-ring might be leaking; try greasing or renewing the O-ring.
H
hamptonerikaAug 28, 2025
What to do if pressurized air escapes at product connection 4 on Henkel LOCTITE EQ RC34?
- N
  Nicholas YoungAug 28, 2025
  If you observe pressurized air escaping at the product connection 4 of your Henkel Controller, carefully tighten the union nut on the product connection 4.
A
Alice JohnsonSep 4, 2025
Why is there an air bubble in the product from my Henkel LOCTITE EQ RC34?
- K
  Kelly AdamsSep 4, 2025
  An air bubble in the product from the Henkel Controller may be due to several reasons. First, check if the product reservoir is empty and refill it if necessary. Second, the dispensing valve might not be correctly connected or could be defective. Third, the product reservoir pressure could be too high; if so, lower the pressure and increase dispensing time.