HEOS Amp - About Wireless Power Saving; Firmware Upgrade

o
About Wireless Power Saving
The Wireless Power Saving feature saves power by turning off power to
the wireless radio inside the HEOS device when the device is connected
to an Ethernet network. If you disconnect the Ethernet cable from the
HEOS device, Wireless Power Saving will automatically turn off and the
wireless radio will turn on so that the HEOS device can be discovered over
your wireless network.
NOTE
If Wireless Power Savings is ON, Wi-Fi power will be temporarily turned on when
accessing the My Devices/(My Devices)/Network screen in the HEOS app or
whenever the Connect button on the device is pressed.
o
Firmware Upgrade
1
Select “Advanced”.
2
Select “Firmware Upgrade”.
3
Enable or disable automatic firmware upgrades.
4
Manually check for a firmware upgrade.
5
Select Save Settings to apply the new settings or
Cancel Changes to revert to the previous settings.
o
About
Viewing Technical Details About the HEOS device.
1
Select “Advanced”.
2
Select “About”.
3
Scroll down to see information about the device’s
a. Hardware
b. Software
c. Device
Contents Setup Use Troubleshooting Status LED Appendix
36