HEPRO User Manual | Side 29
2 Assembly
2.1 Attaching the back
During transit, the back of the chair
is removed. Prior to use, therefore,
the back must be mounted. Place left
metal sleeve A over the long pin B - as
shown in the picture. en place the
right sleeve C over the short pin D. After
this, press the back all the way down on
the pins so that it meets the bottom.
2.2 Power Supply
To enable the chair's electronic functions
to be used, it must be connected to
mains power. e supplied adaptor
must be used here.
C
D
B
A
C
D
To Next Page
Loading...