F-5
Information for Preparation
ATTENTION ON OPERATION
z All washers, oil rings, clamp rings, opening pins shall be duly replaced by a new item when
dismounted.
z Locking of all screws, nuts, cross screws shall be performed in the order of first the large screws
and then the small ones and from inside to outside in opposite angles by tightening the torque
locks.
z All items must use original parts, pure oil and greases.
z All service shall use special tools and general tools to repair.
z All dismounted items requiring for checks shall be duly cleaned and for assembly, all items shall be
duly lubricated.
To Next Page
