MY21H01 - 22_1.0_30.08.2020
73
Operation
6.18.1.4 Pushing in the seat post
1 Open the clamping lever for the quick release on
the seat post.
2 Push in the saddle to the minimum position.
3 Close the clamping lever for the quick release on
the seat post.
6.18.1.5 Folding up the frame
1 Pivot the frame locking lever upwards.
The frame clamping lever can be opened
freely.
2 Open the frame clamping lever.
3 Pivot in the frame as far as it will go.
Figure 59: Closed (1) and opened (2) frame locking lever
6.18.2 Preparing the bicycle so that it is
ready to ride again
The bicycle is prepared so that it is ready to ride
again in eight steps.
1 Use your foot to lower the kickstand completely
before parking.
2 Fold out the frame (see Section 6.18.2.1.)
3 Adjust the stem (see Section 6.5.3).
4 Adjust the saddle (see Section 6.5.1).
5 Fold out the pedal (see Section 6.18.2.2).
6 Insert the battery (see Section 6.11.1.2,
6.11.2.2 or 6.11.3.2)
7 Attach display (see Section 6.13.1.2).
8 Switch on the electric system
(see Section 6.18.2).
6.18.2.1 Folding out the frame
1 Completely fold out the frame.
2 Close the frame clamping lever.
The frame clamping lever rests on the limit stop.
The frame locking lever holds the frame
clamping lever. The frame clamping lever is
closed.
Figure 60: Closed frame clamping lever (1) and closed
frame locking lever (2)
Crash caused by using the opened locking
lever incorrectly
The frame will suddenly fold together while the
cyclist is riding if the locking lever is open. This
will cause a crash with serious injuries.
Only use the pedelec with the locking lever
closed.
To Next Page
Loading...