MY21H01 - 22_1.0_30.08.2020
75
Operation
6.19 Parking the pedelec
1 Switch off the drive system (see
Section 6.12.2).
2 After getting off, use your foot to lower the
kickstand completely before parking. Ensure
that it is stable.
3 Park the pedelec carefully and check that it is
stable.
4 Clean the suspension fork and pedals (see
Section 7.1.)
5 Protect the saddle with a saddle cover if you
park the pedelec outside.
6 Secure the pedelec with a bicycle lock.
7 Remove the battery (see Section 6.11.1.1,
6.11.2.1 or 6.11.3.1) and, where necessary,
your mobile (see Section 6.6.4) to ensure
protection against theft.
Notice
Heat or direct sunlight can cause the tyre pressure
to increase above the permitted maximum
pressure. This can destroy the tyres.
Never park the pedelec in the sun.
On hot days, regularly check the tyre pressure
and adjust it as necessary.
Moisture penetrating at low temperatures may
impair individual functions due to the open
structural design.
Always keep the pedelec dry and free from
frost.
If the pedelec is to be used at temperatures
below 3 °C, the specialist dealer must carry
out an inspection and prepare it for winter use.
The pedelec's force of weight may cause the
kickstand to sink into soft ground, possible
causing the pedelec to topple over as a result.
The pedelec must be parked on firm, level
ground only.
To Next Page
Loading...