How to increase signal when compressing heavily on Heritage Audio Recording Equipment?
If you're not getting enough signal when compressing heavily with your Heritage Audio Recording Equipment, compensate with the GAIN MAKEUP knob to return to a good, healthy level.
What to do if there is still no signal at the back XLR of my Heritage Audio Amplifier?
If there still doesn't appear to be any signal arriving at the back XLR of your Heritage Audio Amplifier, check to see if a jack cable has been left plugged into the front panel D.I.
Why does the mid band boost sound too sharp on my Heritage Audio Amplifier?
If your mid band boost seems too sharp on your Heritage Audio Amplifier, check to see if you have the 'HI Q' button pushed.
How to fix no signal at the back XLR of my Heritage Audio ELITE Amplifier?
If there doesn't appear to be any signal arriving at the back XLR of your Heritage Audio Amplifier, ensure that the GAIN knob is not in the 'Off' position.
What to do if there is no output from my Heritage Audio ELITE?
If there doesn't seem to be any output from your Heritage Audio Amplifier, check to see if the OUTPUT knob is fully turned down, as this will completely attenuate the signal.
Why aren't my condenser microphones working with my Heritage Audio HA-81A EQ Amplifier?
If condenser microphones don't seem to work with your Heritage Audio HA-81A EQ, make sure the red +48 V button is pressed to activate the phantom power sent to the microphone.
What to do if a signal from DAW overloads my Heritage Audio Amplifier?
If you are sending a signal to the Heritage Audio Amplifier from a DAW and it overloads, switch to the LINE GAIN section and use the XLR LINE Input, as it expects a signal with a very different impedance and level.
General| Brand | Heritage Audio |
|---|---|
| Model | ELITE Series |
| Category | Amplifier |
| Language | English |
Details on all controls on the front panel, including limit level, attack, release, ratio, gain makeup, bypass, and indicators.
Explanation of rear panel connectors for line inputs, outputs, and power connection to the PSU04.
Diagram and explanation for connecting the HA-609A for bass recording using DI and microphone inputs.
Diagram and explanation for connecting the HA-609A for guitar recording with FX pedals and amp simulation.
Diagram showing how to integrate the HA-609A into a Digital Audio Workstation (DAW) workflow for mixing.
Diagram illustrating the HA-609A's use on a mix bus, potentially with other outboard gear like equalizers.
Solutions for problems concerning the unit not powering on or VU meters not lighting up.
Troubleshooting steps for no signal, low output levels, or incorrect routing in the DAW.
Guidance on managing peak handling, softened transients, and overall compression levels.
Resolving stereo level mismatches and ensuring compressor/limiter controls are functioning correctly.
To Next Page
