GENERAL INFORMATION
This manual contains information to help an operator to begin using the HERO Eureka
A450/A460 automatic colorant dispenser and insure ease of use and proper maintenance.
Please read this manual carefully and completely before using or servicing your
HERO automatic colorant dispenser.
The Eureka is a simultaneous colorant dispenser that uses progressive cavity volumetric
pumps. Do NOT operate the dispenser or energize any of the pumps without having
colorant in if their respective canisters. Should this occur, the pumps will be
irreparably damaged.
Your HERO automatic colorant dispenser is intended for indoor use only. Do NOT
operate in an outdoors environment.
For proper operation of your HERO automatic colorant dispenser, the following
parameters must be met:
·
Room temperature: 60° F - 105° F (
15°C
-
40
°
C)
·
Relative humidity:
30%
-
90%
As with any other electronic device, the Eureka must be connected to a dedicated
electrical outlet and circuit with the proper grounding system. The AC supply voltage
fluctuations may not exceed 10% of the nominal supply voltage.
The specifications for the LED/Laser used in this equipment are as follows:
650 nm, max.1 mW optical power, Class 2 laser (IEC 60825-1), FDA accession number
07R0483-000
Please read the equipment specifications sheet found elsewhere in this manual.
The equipment warranty will be null and void should any of the above mentioned
criteria not be followed.
Please contact HERO’s 24/7 Help Desk with any questions or if you require
any technical assistance:
1-800-494-4376
customercare@hero.ca
This manual should be kept in a safe place
To Next Page
Loading...
