7
SAFETY INSTRUCTIONS
Please read the instructions carefully before installing and operating the machine, as a
personal safety measure as well as to avoid needless damage to the machine
HERO EUROPE declines any responsibility should the following instructions not be
followed:
Do not turn on a damaged machine (for example, if the machine is damaged during
carriage). If in doubt, first contact the back up service or the reseller.
Position and connect the machine by carefully following the installation instructions
and by respecting the conditions stated in this handbook.
All the instructions and local safety regulations must be observed.
The machine must only be connected to a wall socket assembled according to
regulations, with the grounding circuit and the tension value in compliance with what
is written on the machine plate.
The user must maintain the machine in good working condition and replace any
broken components.
Any assistance on the machine, other than routine, can only be carried out by a
qualified technician. Make sure that the power cable is not plugged into the
socket whilst the machine is being repaired.
A standard machine is solely suited to dosing water-diluted colorant pastes in
standard paint cans.
The elastomer parts inside the dosing circuits could undergo damage if other
thinners are used.
Never set the dosing pumps going if there is no colorant in the respective circuit,
otherwise the friction within the pumps would lead to an increase in temperature
capable of damaging the pumps.
To Next Page
Loading...
