HERO Ultrablend Trumix 1 - User Manual

TRUMIX VORTEX BLENDER
OPERATING AND SERVICE MANUAL
MECHANICAL TIMER AND DIGITAL PANEL MODELS
I.C.T.C. Holdings Corporation
HERO Products Group
720 Eaton Way.
Delta, BC V3M 6J9
Canada
Phone 800.494.4376 • Fax 866.778.3323
Revision 2.00

Summary

Section 1: Overview

1-3: Setup

Instructions for unpacking and setting up the TruMix vortex blender.

Section 2: Operating Instructions

2-1: Warnings

Crucial safety warnings including grounding, hazardous locations, and operational precautions.

2-2: General Operating Instructions

General procedures for loading, operating, and unloading the blender.

Section 4: Troubleshooting

4-1: Identifying Problems

General introduction to troubleshooting common issues with the TruMix blender.

4-1-1: The Mixer Display Is Blank

Identifies potential causes and checks for a blank display issue on the mixer.

4-1-2: The Mixer Displays the Message “Stop”

4-1-3: The Mixer Displays the Message dL

4-1-5: The Mixer Display Counts Down But Does Not Mix

4-1-6: The Door Will Not Open

4-1-7: Mixer Display Counts Down, Mixing Stops Early

4-1-8: The Mixer Is Making Excessive Noise

Section 5: Service

5-1: Cabinet Removal; Replacement

5-2: Mechanical Drive Assembly

5-3: Electrical Assembly

HERO Ultrablend Trumix 1 Specifications

General

Power	1000 W
Material	Plastic
Voltage	220-240V
Frequency	50-60Hz
Capacity	2.0L