HERO Ultrablend Trumix 5 User Manual

TRUMIX VORTEX BLENDER
OPERATING AND SERVICE MANUAL
MECHANICAL TIMER AND DIGITAL PANEL MODELS
I.C.T.C. Holdings Corporation
HERO Products Group
720 Eaton Way.
Delta, BC V3M 6J9
Canada
Phone 800.494.4376 • Fax 866.778.3323
Revision 2.00

HERO Ultrablend Trumix 5 Specifications

General

Power	1000 W
Speed Settings	5
Material	Plastic
Voltage	220-240 V
Frequency	50/60Hz

Summary

SECTION 1: OVERVIEW

1-3: SETUP

Unpacking

Step-by-step instructions for safely unpacking the TruMix blender and preparing it for operation.

SECTION 2: OPERATING INSTRUCTIONS

2-1: WARNINGS

Important safety warnings regarding grounding, hazardous locations, and proper operating practices for the blender.

2-2 GENERAL OPERATING INSTRUCTIONS

General instructions for operating the TruMix vortex blender, covering loading, operation, and unloading procedures.

2-2-1 LOADING

Instructions for correctly loading containers into the TruMix blender's receiving bucket, specific to different models.

2-2-2 OPERATION

2-2-3 UNLOADING

2-3 TRUMIX MODELS

2-3-1 MECHANICAL TIMER MODEL

2-3-2 TIME SELECT DIGITAL PANEL MODEL

2-3-3 PRESET TIME DIGITAL PANEL MODEL

SECTION 3: MAINTENANCE

SECTION 4: TROUBLESHOOTING

4-1: IDENTIFYING PROBLEMS

4-1-1: THE MIXER DISPLAY IS BLANK

Troubleshooting steps for when the TruMix blender's display screen shows no information.

4-1-2: THE MIXER DISPLAYS THE MESSAGE “STOP”

Troubleshooting steps for when the TruMix blender displays a 'STOP' message, indicating a safe stop.

4-1-3: THE MIXER DISPLAYS THE MESSAGE "dL"

Troubleshooting steps for when the TruMix blender displays a 'dL' message, related to door interlock.

4-1-5: THE MIXER DISPLAY COUNTS DOWN BUT DOES NOT MIX

Troubleshooting steps for when the TruMix blender's timer counts down but the mixing action does not occur.

4-1-6: THE DOOR WILL NOT OPEN

Troubleshooting steps for addressing the problem where the TruMix blender's door remains locked and won't open.

4-1-7: MIXER DISPLAY COUNTS DOWN, MIXING STOPS EARLY

Troubleshooting steps for when the TruMix blender stops mixing before the set time is complete.

4-1-8: THE MIXER IS MAKING EXCESSIVE NOISE

Troubleshooting steps for diagnosing and resolving excessive noise issues in the TruMix blender.

SECTION 5: SERVICE

5-1 CABINET REMOVAL / REPLACEMENT

5-1-1 REMOVE TRUMIX 1 CABINET

5-1-2 REPLACE TRUMIX 1 CABINET

5-1-3 REMOVE TRUMIX 5 / XHD CABINET

5-1-4 REPLACE TRUMIX 5 / XHD CABINET

5-2 Mechanical Drive Assembly

5-2-1 BUCKET REMOVAL & REPLACEMENT

5-3 ELECTRICAL ASSEMBLY

5-3-1 MECHANICAL TIMER REPLACEMENT

5-3-2 FUSE REPLACEMENT

Instructions for safely replacing fuses in the digital panel TruMix 1/5/XHD models.

Ergo 5 Fuse Replacement

Instructions for safely replacing fuses in the Ergo 5 model TruMix blender.

5-3-3 CIRCUIT BREAKER REPLACEMENT

5-3-4 POWER CORD REPLACEMENT

5-3-5 LIMIT SWITCH / MAGNETIC SWITCH REPLACEMENT