HERO Ultrablend Trumix Series

Need help?

Do you have a question about the HERO Ultrablend Trumix Series and is the answer not in the manual?

Summary

SECTION 2: OPERATING INSTRUCTIONS

2-1: WARNINGS

Crucial safety warnings and precautions for operating the TruMix blender.

2-2: GENERAL OPERATING INSTRUCTIONS

Detailed procedures for loading, operating, and unloading the TruMix blender.

2-2-1: LOADING

2-2-2: OPERATION

2-2-3: UNLOADING

SECTION 4: TROUBLESHOOTING

4-1: IDENTIFYING PROBLEMS

Guide to identifying common issues and their potential causes.

4-1-1: THE MIXER DISPLAY IS BLANK

Troubleshooting steps when the mixer display shows no information.

4-1-2: THE MIXER DISPLAYS THE MESSAGE STOP

Troubleshooting when the mixer displays a "STOP" message.

4-1-3: THE MIXER DISPLAYS THE MESSAGE dL

Troubleshooting the "dL" alarm on the digital panel.

4-1-4: THE MIXER MOVES ON THE FLOOR

4-1-5: THE MIXER DISPLAY COUNTS DOWN BUT DOES NOT MIX

4-1-6: THE DOOR WILL NOT OPEN

Troubleshooting the interlock system when the door cannot be opened.

4-1-7: MIXER DISPLAY COUNTS DOWN, MIXING STOPS EARLY

Addressing issues where mixing stops prematurely after counting down.

4-1-8: THE MIXER IS MAKING EXCESSIVE NOISE

SECTION 5: SERVICE

5-1: CABINET REMOVAL; REPLACEMENT

Procedures for removing and replacing blender cabinets.

5-1-1: REMOVE TRUMIX 1 CABINET

5-1-2: REPLACE TRUMIX 1 CABINET

5-1-3: REMOVE TRUMIX 5; XHD CABINET

5-1-4: REPLACE TRUMIX 5; XHD CABINET

5-2: MECHANICAL DRIVE ASSEMBLY

Procedures for servicing the mechanical drive components.

5-2-1: BUCKET REMOVAL & REPLACEMENT

5-3: ELECTRICAL ASSEMBLY

Procedures for servicing the electrical components of the blender.

5-3-1: MECHANICAL TIMER REPLACEMENT

5-3-2: FUSE REPLACEMENT (Digital Panel - TruMix 1;5;XHD)

5-3-3: CIRCUIT BREAKER REPLACEMENT

5-3-4: POWER CORD REPLACEMENT

5-3-5: LIMIT SWITCH; MAGNETIC SWITCH REPLACEMENT