HERON 8896231 - Assembly Instructions; Assembly Model 8896322; Assembly Model 8896324

1010
Assembly Model 8896322
ToolsRequired
1. Adjustable wrench
2. Philips screwdriver
Instrucons:Verylileassemblyisrequiredforthismodel
Note:Allhardwarespeciedisprovidedwiththeassemblykit
1. Removethegeneratorbodyandpartsboxfromthepackaging.
2. Connectthewiringtothebaery(redposiveandblacknegave).Usethesmallscrewsprovided
3. Fillthegeneratorwithoil.(10W-30oil,1100ml)
1111
8896231 • 8896322 • 8896324
Assembly: Model 8896324
ToolsRequired
1. Socket set
2. Adjustable wrench
3. Philips screwdriver
Instrucons:
Note:Allhardwarespeciedisprovidedwith
theassemblykit
1. Removethegeneratorbodyandpartsbox
fromthepackaging.
2. Using4oboltsandnutssecureoneaxleassemblytothegeneratorframe.
Notethereare4pre-drilledholesintheframeforeachaxlelocatedintheframememberunderthe
engine.
3. Repeatstep2forthesecondaxleassembly.
4. Using1oboltandnutsecureoneoftherubberfeettothemetalfootbracket.
5. Repeat step 4 above for the second rubber foot.
6. Using2oboltsandnutssecurethefootassemblytothegeneratorframeusingthepre-drilledholes
intheframememberunderthealternatorendofthemachine.
7. Using1oboltandnutsecureoneofthearmassembliestothegeneratorframe.(Usetheball
lockpinprovidedwiththearmassemblytosecurethearmintheextendedorretractedposionas
required)
8. Repeatstep7abovewiththesecondarmassembly.
9. Connectthewiringtothebaery(redposiveandblacknegave).Usethesmallscrewsprovided.
10. Fillthegeneratorwithoil.(10W-30Oil1.3l)