Need help?Do you have a question about the Heta Scan-Line and is the answer not in the manual?
Ensures no combustible material is placed within the indicated safety distance from the stove and rotating base.
Consideration of stove rotation when calculating floor plate size; surface must be flat and level.
Owner's responsibility for safety requirements, inspector checks, and attention to heat radiation through glass.
Instructions on how to remove stop screws to achieve 360° rotation or reduce it to 120°.
Placing the base on the floor in a neutral position and aligning the stove door with the neutral line.
Marking the ceiling for the flue connection after positioning the base according to the pivot centre.
Replacing the factory fitted spigot with the supplied turn spigot featuring ball bearings.
To Next Page
General