HETRONIC RX BMS2-PWM - User Manual

Questions and Answers

H
hamiltonericaAug 16, 2025
What to do if all crane/machine motions operate intermittently with HETRONIC RX BMS2-PWM Receiver?
- B
  Brian RamosAug 16, 2025
  If all crane/machine motions operate intermittently when using the HETRONIC Receiver, consider the following: * Ensure the receiver antenna is tightened and replace it if necessary. * If using an external antenna, tighten the antenna and ground connection. * Control wiring must be run separately from power wiring. * Check all connectors inside the receiver and reseat if necessary.
T
thomashillAug 22, 2025
How to fix HETRONIC Receiver transmitter that won't transmit?
- A
  Adam TaylorAug 22, 2025
  If your HETRONIC Receiver transmitter turns on but doesn't transmit (Power LED not flashing), here are a few things to check: * Replace the battery with a fully charged one. * Check the fuse and replace it if necessary. * Check the wiring on the key switch. Replace the key switch, wiring, or contact element if needed.
C
Curtis MannAug 28, 2025
What to do if some crane/machine motions operate intermittently with HETRONIC Receiver?
- N
  Nicholas EvansAug 28, 2025
  If some crane/machine motions operate intermittently when using the HETRONIC Receiver, consider the following: * Check wiring from receiver to plug and from plug to crane/machine motion actuator, as the crane/machine motion wiring may be loose. * Check all connectors inside the receiver and reseat if necessary. * Control wiring must be run separately from power wiring.
C
Christopher WilliamsNov 4, 2025
What to do if HETRONIC RX BMS2-PWM Receiver doesn't respond when the transmitter is on?
- K
  Karen HarrisNov 4, 2025
  If the HETRONIC receiver isn't responding even when the transmitter's power LED is flashing, here's what you can check: * Ensure the E-Stop switch isn't engaged by pulling out the E-Stop pushbutton and pressing the Start/Horn pushbutton. * Verify the transmitter is within the receiver's range and press the Start/Horn pushbutton. * Make sure all control devices (joysticks, paddle levers, or switches) are in the center (neutral) position when activating the Start button. * Confirm the receiver has power. * Inspect the receiver for blown fuses and replace them if necessary. * Check the transmitter's E-Stop pushbutton for damage and the wiring to the contact element for broken or disconnected wires; repair or replace as needed. * Examine the wiring on the E-Stop module, decoder ...
V
victorianelsonNov 9, 2025
Why HETRONIC RX BMS2-PWM Receiver system will not initialize?
- B
  Bryan BryanNov 10, 2025
  If your HETRONIC Receiver system fails to initialize after the normal start-up, consider these potential causes: * **E-Stop Reset:** You may need to push the Start button again. If initializing from an E-Stop condition, press the Start button twice: once to clear the E-Stop, and again to start the system. * **Joystick/Paddle Lever Position:** Ensure all joysticks and paddle levers are in the center position when activating the Start button. * **E-Stop Switch:** Make sure the E-Stop switch is disengaged (pulled out). Restart the system by pressing Start twice. * **Battery Charge:** Check the battery to ensure it's fully charged. Replace it if necessary. * **Receiver Power:** Verify power is applied to the receiver by checking the diagnostic Display on the side. Also, ensure the s...