Technik für Möbel
13
Advice
`Dimensions in millimeters (inch approximations as noted). Subject to technical modifications without notice.
Drawer slides for wooden drawers
`Quadro
`Technical information
Mounting specifications – (Quadro V6 / Quadro 4D V6, face frame application)
Cabinet front edge
Min. setback for inset or roll out tray =
Decorative drawer front thickness + 3.5 mm (1/8“).
Trial recommended! See details below for adjustment possiblities.
Blocking behind frame
Minimum/maximum cabinet depth (see below)
(Rear attachment options see page 12)
Face frame application with
overlay decorative front
Face frame application with
inset decorative front
Front gap 1.5 mm (1/16“)
Setback 2 mm (3/32“)
10 mm (3/8“)
37 mm (1 7/16“)
Inset application increases minimum cabinet depth!
Drawer box length
mm (inch)
Min-Max cabinet depth with
metal rear attachment
mm (inch)
Min-Max cabinet depth with
plastic rear attachment (TennTex C-307)
mm (inch)
229 mm (9") Quadro V6 250 - 300 mm (9 7/8“ - 11 3/4“) 270 - 297 mm (10 5/8“ - 11 11/16“)
305 mm (12") 326 - 376 mm (12 7/8“ - 14 3/4“) 346 - 373 mm (13 5/8“ - 14 11/16“)
381 mm (15") 402 - 452 mm (15 7/8“ - 17 3/4“) 422 - 449 mm (16 5/8“ - 17 11/16“)
457 mm (18") 479 - 529 mm (18 7/8“ - 20 3/4“) 498 - 525 mm (19 5/8“ - 20 11/16“)
533 mm (21") 555 - 605 mm (21 7/8“ - 23 3/4“) 574 - 601 mm (22 5/8“ - 23 11/16“)
610 mm (24") 631 mm (24 7/8“) no rear attachment, must be blocked out
Minimum / maximum cabinet depth (Quadro V6 / Quadro 4D V6, face frame application)
To Next Page
Need help?
General
