Harrington Generators International
11HRD Diesel Generator 498-1052
Safety
The generator is fi tted with a number of labels that alert the user to the safe operation and safety requirements.
A full explanation of these is contained here. If any of the labels are missing or unreadable a duplicate should be
obtained and fi tted.
Label Part No, Qty, Location Description
Pt No. 499-945-002
Qty 1
Roof Panel Side Next to Exhaust
CAUTION HOT EXHAUST
The exhaust pipe is shielded as much as
is practical but the fi nal outlet is hot.
Pt No. 499-945-003
Qty 1
On Filler Cap
DIESEL FUEL ONLY
This generator must only be fi lled with
commercial diesel fuel containing up to
10% bio-fuel. If special grades of diesel
e.g. 100% Bio-Diesel are to be used
consult HGI fi rst to discuss its suitability.
Pt No. 499-945-004
Qty 2
Next to Inlet Outlet Vents
INLET AND OUTLET VENTS TO BE
KEPT CLEAR
These must be kept free from obstructions
to allow a free fl ow of cooling air or the
engine and alternator could over heat.
Pt No. 499-945-005
Qty 1
On Roof
NO STEP
The generator should not be used as a
step.
Pt No. 499-945-015
Qty 1
On Control Panel 3 phase
Generators
FUSE IDENTIFICATION
Informational label advising the Identity of
the Fuse.
Pt No. 499-945-008
Qty 1
Inside Terminal Pod
EARTH POINT
An M10 brass earth stud is supplied next
to the output sockets for the external earth
connection.
To Next Page