14
FAQS
What lubricants should I use with the
All-U-Need?
We recommend using only clean water with
the All-U-Need. If desired, you may add a water
soluble coolant to the water.
Can I reuse water for diamond
grinding?
You can, but we don’t recommend this. When you
reuse water, you risk getting contamination on
your diamond discs which increases the chances
of unwanted scratches on your work pieces. For
best results, use clean water every time you use
the All-U-Need.
How do I clean the white catch tray?
To prevent the drain tube from clogging, flush
the white catch tray aer every use on the All-
U-Need by taking a small bucket of clean water
and pouring the water into the catch tray so the
leover rock sediment gets flushed down the
drain tube. Once you see all of the sediment
gone and the white catch tray is clean, your
All-U-Need will be ready for the next use. If you
need to remove the white catch tray for further
cleaning, do so by removing the arbor with the
Allen wrench that is included with the All-U-Need
instruction manual.
Do you sell electrical spare parts for
my All-U-Need? Whom do I contact if
I need a repair or replacement for my
All-U-Need?
Due to the technical nature of our machines,
we do not oer electrical spare parts for you to
install yourself such as motors, speed controllers,
rectifiers, etc. Instead, we oer a repair
service that is done in-house by our qualified
technicians. For more information about our
repair service, visit hitechdiamond.com/repairs.
To Next Page
Loading...
General