4. Charging
5. Riding Basics
5
4
Insert the charger plug in Fill and fix the rubber
plug after the charging
Open the rubber cover
Your scooter will be fully charged when the LED light on the charger changes from red
(charging) to green (fully charged).
After a period of full charge, it will automatically cut off the charging.
Even so, we still don't recommend to charge your scooter for a long time.
Do not connect the charger if the charging port is wet. Cover the charging port when not use.
1. Turn the power on, and check the power indicator.
Note: The scooter can not be turned on during charging
Always wear a helmet and safety gear so to
avoid falling and injury during the driving
learning,
as shown in the figure.
2. Step on the deck with one foot, and slowly kicks off
the other on the ground.
3. When the scooter starts to coast, put both
feet on the deck and press the throttle
(the throttle initiates once the coasting
speed exceeds 3.1 mph).
4. Release the throttle to reduce the speed
slowly. Squeeze the brake lever for a sudden
brake.
5. Tilt your body to the steering direction as you
turn, and turn the handlebar slowly.
To Next Page
Loading...
