CC01-UM-B01-02.12-ENG-01.12.16
User Manual coCrypt B Selfkey
This guide describes the first time set-up procedure (sections A and B) for the 2-factor coCrypt B USB device
followed by a description (section C) of how to use coCrypt in daily operation. The following sections gives
information about name change, PIN change etc. You may also find additional or updated information at
www.hiddn.no/support.
A. Insertion of the Keycard Break-out Module (SIM card):
2. Remove the keycard break-out module (SIM card) from your keycard and insert it
into the holder as shown below. Verify that the card is marked with "B". Make sure
you insert it with the active (golden) area facing towards the top area (display area)
of the coCrypt B and note the cut-out corner. See the pictures below:
B. First Time Setup
1. Press to power on. The display shows “coCrypt B”. Insert your coCrypt B into a USB port on
the PC. If necessary, use the 20 cm extension cable included in the box. DO NOT unplug the
coCrypt B until you have reached point 5 in this section.
2. Wait until the display shows ”Initialize [Y/N]” (May take up to 60 seconds).
3. Press to answer Yes. The display will show “Initialize [Y/N] Y”. Press Enter . (If you
press N you will get the message “Please restart”. Remove the coCrypt B from the
computer and go back to point 1 in this section to restart the operation).
4. The display shows “Do NOT unplug”. Make sure the device does not lose power (do NOT unplug
the device from the computer and do not turn off the computer) until the display shows
“Init OK, restart”. This may take several minutes.
5. Restart hiddn coCrypt B by removing it from the PC and then reinsert it.
6. The display shows " New PIN". Key in your chosen PIN code. If you type an error, undo the typo
by pressing . When finished press Enter . It is a system requirement that the PIN code
must have at least 7 digits and at least one digit must be offset by 2 or more compared to the
preceding one. (Examples: “1-2-3-4-5-6-7”, “0-0-0-1-0-0-0”, “4-3-2-1-2-3-4”, “7-6-5-4-3-2-1”, “0-
0-0-0-0-0-0”, “1-1-2-2-3-3-4-4” are all non-acceptable while “0-0-0-2-0-0-0” and “9-7-6-5-4-3-1”
are acceptable).
7. The display shows “Confirm”. Reenter your new PIN code and press Enter once more. The
display now shows “SD ready” and will also show “USB locked” since the system in this coCrypt B
version is set up with the extra USB connection logically blocked from use. (The display will show
“PIN too weak” and then “New PIN:” in case the chosen PIN code does not meet the system
requirements. In that case go back to step 6 and reenter another PIN code).
To Next Page
Need help?
General