CC01-UM-B01-02.12-ENG-01.12.16
5. Enter the old PIN code and press to confirm. The display shows “New PIN”.
6. Enter the new PIN code (equal length) and confirm with
7. The display shows “Confirm:”. Enter the new PIN code once more and confirm with
8. The display shows “Changing PIN”.
9. The display then shows “PIN changed” followed by “Connect to computer”.
10. Let the coCrypt B power off by itself or power off by pressing for at least 2-3 seconds.
11. Restart the coCrypt B in the normal way. Make sure you have a copy of your new PIN code stored
in a secure place.
E. Change Device Name:
1. Press and hold while momentarily pressing to power on.
2. Release the when the text “Admin menu” appears in the display followed by the text
“1.System Info”.
3. Press twice. The text “3. Set name” will appear in the display.
4. Press to confirm your choice. The display will show the text “PIN: “
5. Enter the correct PIN code and confirm by pressing
6. The display will now show “Pin accepted” followed by “Enter dev name” followed by the current
device name/number.
7. Remove the old name by repeatedly pressing until the display is blank.
8. Enter your new device name by repeatedly pressing on the appropriate buttons until the right
letters appear. Note that you may choose between small and capital version of each letter as
well as numbers. Delete any incorrect letter/number by pressing
9. You can make a space in your text by quickly pressing twice.
10. When finished, confirm by pressing
11. Normal operations can now continue.
F. Erase Data:
The Erase Data command will erase the media key in your Key card (SIM-card) and generate a new
one. Any data encrypted with your coCrypt B device will be cryptographically erased and cannot
be recovered. However, the PIN code is not erased and will remain the same after the erase
operation.
1. Press to power on your coCrypt B.
2. Press and hold the until the message “Admin menu” is displayed.
3. Press several times until the message “Erase data” is displayed.
4. Then press Enter . The display will change to “Confirm [Y/N]”.
5. Press . The “Y” for Yes is displayed. Press Enter to confirm.
6. The display shows “PIN: “. Enter your PIN number and press to confirm.
7. The display shows “Device erased”.
8. All data on your coCrypt B is now erased and you may begin the processing of storing new data, using
the same PIN number as previously recorded.
To Next Page
Loading...