Operations
Installation
Incorrect engine height or obstructions to smooth water ow (such as the design or condition of
the boat, or accessories such as transom ladders or depth nder transducers) can create airborne
water spray while the boat is cruising. Severe engine damage may result if the motor is operated
continuously in the presence of airborne water spray.
During water testing check the buoyancy of the boat, at rest, with its maximum load. Check that
the static water level on the exhaust housing is low enough to prevent water entry into the
powerhead, when water rises due to waves when the outboard is not running
Mounting the outboard motor
• Overpowering a boat could cause se vere instability. Do not install an outboard motor with more
horsepower than the maximum rating on the capacity plate of the boat. If the boat does not have a
capacity plate, consult the boat manufacturer.
• The information presented in this section is intended as reference only. It is not possible to
provide complete instructions for every possible boat and motor combination. Proper mounting
depends in part on experience and the specic boat and motor combination.
Improper mounting of the outboard motor could result in hazardous conditions such as poor
handling, loss of control, or re hazards. Observe the following:
• For permanently mounted models, your dealer or other person experienced in proper rigging
should mount the motor. If you are mounting the motor yourself, you should be trained by an
experienced person.
• For portable models, your dealer or other person experienced in proper outboard motor mounting
should show you how to mount your motor.
Mount the outboard motor on the center line(keel line) of the boat, and ensure that the boat itself
is well balanced. Otherwise the boat will be hard to steer. For boats without a keel or which are
asymmetrical, consult your dealer.
1.Center line(keel line)
1
13
To Next Page
Loading...
Need help?
General
