Hides DC-105 - Page 15

Easy HD Expressway!
WWW.HIDES.COM.TW 15
Note: it’s recommended that the [Video Bitrate] should be
less than [modulation data rate] by 20% at least.
If [modulation data rate] is too low, it may cause video glitch.
Flicker
50 Hz or 60Hz room light flicker
Negligible if LED light source or outdoor sun light
60Hz
GOP
Group of picture size
Higher GOP , higher compression efficiency but poorer
quality
30
CVBS
Select the TV standard for the analog video CVBS output
PAL, NTSC or Disable
PAL
Fast Playback
Fast Playback Mode can shorten the latency at the cost of video
glitch sometimes
Disabled
Enable Audio
Enable MIC-in feature
When MIC-in is enabled, it’s recommended to disable analog
video CVBS output feature for better audio quality.
Disable
Provider Name
Channel provider name (for SDT)
[Hides]
Service Name
Channel service name (for SDT)
[DC-105]
SIPSI_Table_Duration
Duration in minutes.
0: SI/PSI table always be sent
N: After N minutes, TS SI/PSI table will not be sent. And the
TV system could only scan the DTVCAM channel in this
period.
[0]
PTSPCR_Interval
(Latency)
Adjust TS PTS and PCR interval in ms. It is trade-off with
video latency and video smooth.
300ms