11
Power On & Unlock
The display is equipped with five buttons on the corresponding operating unit power
on/off ,plus ,minus ,light and toggle .
Long press to power on/off the display. If you do not use the electric bike for more than 10
minutes, the meter will automatically shut down.
When the display is powered on, it will show the Current Speed (km/h) and Odometer (km) by
default. Short press to switch between Odometer (km), Trip Odometer(km), Maximum Speed
(km/h), and Average Speed (km/h).
Long Press and hold , the electric bicycle enters the walk boost mode. The electric bicycle will
walk at a fixed speed of 6 km per hour and the display shows . Release the button to stop the power
output immediately and restore to the state before walk boost.
The walk boost mode can only be used when pushing the electric bicycle, please do not use it
while riding.
Press the to make the controller turn on the lights.Press again to make the controller turn
off the lights.
Press / to switch gears of the electric bicycle, thus changing the motor output power.
After unlocking, please wear a helmet and protective gear before cycling, and ensure that all
functions of the electric bike are normal before starting your cycling.
After cycling, please press and hold the power button on the instrument panel to turn off the
power.
To Next Page
Loading...
