Hidoes HD-B6 - Error Code; Error Code Troubleshooting Guide

19
Error Code
Error Code
Fault
Diagnostic Step
Solution
E001
Controller failure
Controller failure
Replace controller
E002
Communication fail
The instrument cannot receive the signal from the controller.
Check whether the green line of the controller is connected
properly.
Replace Instrument
E003
Motor Hall failure
Check whether the motor wires are connected properly or
whether the colored wires are connected incorrectly.
If there is no problem with each circuit, the
motor needs to be replaced.
E004
Accelerator failure
Check if the accelerator is reset.
After the accelerator is reset, if the handlebar
signal is still less than 0.75V, the accelerator
needs to be replaced.
E005
Brake lever failure
After the system is powered on, check whether the brakes are
working properly.
If the brake signal is less than 0.75V for a long
period of time, the brake lever needs to be
replaced.
E006
Phase fault
Check whether the motor wires are connected properly or
whether the colored wires are connected incorrectly.
If there is no problem with each circuit, the
motor needs to be replaced.