Need help?Do you have a question about the Hifonics Zeus ZRX2000.4 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Total Harmonic Distortion (THD) | < 0.05% |
| Frequency Response | 10 Hz - 30 kHz |
| Signal-to-Noise Ratio | >95dB |
| Damping Factor | > 200 |
| Input Sensitivity | 200 mV - 6 V |
| Bass Boost | 0-12dB |
| Bass Boost Frequency | 45 Hz |
| Fuse Rating | 30A x 2 |
| Power Output (RMS) | 2000 Watts |
| Crossover Type | Variable |
| Low Pass Crossover Frequency / Filter | 40 Hz - 250 Hz |
Discusses system design, amplifier placement, and heat dissipation for optimal performance.
Details amplifier mounting, wiring practices, and proper grounding techniques.
Explains using appropriate gauge cables and connection methods for power and ground.
Outlines the correct order for connecting cables to prevent system damage.
Provides a step-by-step procedure for safely powering on the audio system.
Covers general capabilities, input sensitivities, crossovers, and diagnostic LEDs of the ZRX series.
Details X-OVER switch, Bass EQ, and input/output functions for 2-channel models.
Explains features of 4-channel amps, including mode switch and separate controls.
Describes controls and functions specific to the mono 1-channel amplifier models.
Guides on basic stereo application for 2-channel amplifiers, including connections and settings.
Explains the mono bridging method for 2-channel amplifiers, including wiring and switch settings.
Guides on using 4-channel amplifiers for discrete 4-channel full range systems.
Explains creating 3-channel systems by mono bridging channel pairs on 4-channel amplifiers.
Combines 2 and 4 channel amps for front/rear highs and mono sub bass systems.
Details using mono 1-channel amplifiers in bi-amplification systems and wiring for dual speaker terminals.
Lists features and specifications for the 2-channel ZRX amplifiers.
Lists features and specifications for the 4-channel ZRX amplifiers.
Lists features and specifications for the 1-channel mono D Class ZRX amplifiers.
Guidance on setting High Pass, Low Pass, Subsonic, and Bass EQ controls for optimal performance.
Instructions on matching amplifier input sensitivity to head unit output for balanced system levels.
Advice on balancing levels for midrange and highs in active systems.
Covers PROTECT system triggers, heatsink overheating, and related causes.
Addresses low output power, blown fuses, and system failure to turn on.
Discusses troubleshooting hiss, electrical interference, and engine-related noises.
Details the one-year warranty for amplifiers and accessories against defects.
Lists conditions and damages not covered by the limited warranty.
Provides information on obtaining extended warranty coverage.
Explains the MAXXLINK labeling system and associated product performance and warranty.
Describes system levels and their corresponding MAXXLINK product tiers.
To Next Page