Need help?Do you have a question about the Hifonics Zeus ZRX1500.1D and is the answer not in the manual?
General| Channels | 1 |
|---|---|
| Amplifier Class | Class D |
| Signal to Noise Ratio | >95dB |
| Damping Factor | >200 |
| Low Pass Filter | 35Hz - 250Hz |
| Bass Boost Frequency | 45Hz |
| Fuse Rating | 150A |
| RMS Power at 2 Ohms | 1000W |
| RMS Power at 1 Ohm | 1500W |
| Power Output (Peak) | 3000W |
| Frequency Response | 10Hz - 300Hz |
| Input Sensitivity | 0.2V - 6V |
| Bass Boost | 0dB - 12dB |
| Phase Shift | 0 - 180 degrees |
| Operating Voltage | 9V - 16V |
| Efficiency | 85% |
Describes system design principles for optimal car audio setup.
Covers physical mounting and placement for optimal heat dissipation.
Provides general guidelines for running wires away from noise sources.
Details power/ground wiring requirements and wire gauge charts.
Outlines the correct order for connecting various audio cables.
Step-by-step guide for initial system power-on and testing.
General features and capabilities of the Zeus ZRX amplifier series.
Details specific features and controls for 2-channel models.
Details specific features and controls for 4-channel models.
Details specific features and controls for 1-channel mono models.
Application guide for stereo full-range system setup.
Application guide for mono bridging method with 2-channel amps.
Application guide for discrete 4-channel full range system.
Application guide for 3-channel setup using mono bridging.
Describes a bi-amplification system setup for front/rear highs and mono sub.
Basic application for bi-amplification systems using mono amps for subwoofers.
General setup, High Pass, Bass EQ, and Low Pass for multi-channel amps.
Matching amplifier input sensitivity to head unit output signal level.
Balancing levels for highs/midrange against bass in multi-way systems.
General setup, Subsonic, Bass EQ, and Low Pass for mono amps.
Explains the amplifier's protection mode and LED indicators.
Details causes and solutions for amplifier heatsink overheating.
Troubleshooting steps for low output power from the amplifier.
Identifies common reasons for amplifier fuses to blow.
Steps to diagnose why the system or amplifier does not turn on.
Methods to diagnose and resolve system noise issues.
Diagnosing noise that changes with engine RPM.
Troubleshooting steps for persistent whining noises.
Details the features of the MX-1 Premium High To Low Level Converter.
Details the features of the MX-3 Bass Controller.
Details the features of the MX-2 Deluxe High To Low Level Converter.
Details the features of the MX-4 Add A Sub High To Low Level Converter.
To Next Page