Need help?Do you have a question about the Hifonics Zeus ZRX2000.1D and is the answer not in the manual?
General| Amplifier Class | D |
|---|---|
| Number of Channels | 1 |
| Peak Power | 4000 Watts |
| Total Harmonic Distortion (THD) at RMS Output | <0.1% |
| Signal to Noise Ratio | >95dB |
| Frequency Response | 10 Hz - 250 Hz |
| Bass Boost | 0-12dB |
| Input Sensitivity | 0.2V - 6V |
| Fuse Rating | 200A |
| Phase Shift | 0-180° |
| Efficiency | >85% |
| RMS Power at 1 Ohm | 2000W |
| RMS Power at 2 Ohms | 1400W |
| RMS Power at 4 Ohms | 800W |
| Crossover Type | Variable Low Pass |
Discusses the importance of system design for car audio.
Covers physical mounting and placement advice for amplifiers.
Details proper gauge wire selection and connection for power and ground.
Outlines the step-by-step process for connecting components safely.
Provides a method for safely turning on the system for the first time.
General overview of features across the Zeus ZRX amplifier line.
Details specific features for ZRX 2-channel models.
Details specific features for ZRX 4-channel models.
Details specific features for ZRX 1-channel models.
Describes the basic stereo application for 2-channel amps.
Explains how to use a 2-channel amp for mono bridged operation.
Illustrates setting up a 4-channel amp for discrete full range use.
Shows how to configure a 4-channel amp for 2 or 3 channel operation.
Configures amps for front/rear highs and mono sub bass.
Describes the fundamental use of 1-channel mono D class amplifiers.
Guides on setting High Pass, Bass EQ, Low Pass, and Level controls for 2/4 channel amps.
Guides on setting Subsonic, Bass EQ, Low Pass, and Level controls for 1-channel amps.
Explains the amplifier's protect mode and diagnostic indicators.
Details reasons for amplifier overheating and solutions.
Addresses common causes of low output power from amplifiers.
Guides on diagnosing why amplifier fuses may be blowing.
Helps identify issues when the system fails to turn on.
Covers troubleshooting hiss, white noise, and electrical interference.
Describes the MX-1 Premium High To Low Level Converter.
Details the MX-3 Bass Controller accessory.
Describes the MX-2 Deluxe High To Low Level Converter.
Outlines the MX-4 Add A Sub High To Low Level Converter.
To Next Page