High End Systems Studio Spot 250 - Page 9

Studio Spot
®
250 / Studio Color
®
250 User Manual page ix
Studio Color
®
250 Menu Map ............................................................................4-10
Fixture Options ......................................................................................................... 4-20
Address Menu (ADDR) .......................................................................................4-20
Set Menu (SET) ...................................................................................................4-20
Setting Factory Defaults (FACT) ...................................................................4-21
Swapping Pan and Tilt (SWAP) ....................................................................4-22
Inverting Tilt (T/IN) .......................................................................................4-22
Inverting Pan (P/IN) .......................................................................................4-23
Changing the Display Output (DSPL) ...........................................................4-23
Inverting LED Characters (D/IN) ..................................................................4-24
Changing the Control Method (CHNL) ........................................................4-24
Setting the Lamp Warning Message (LMPL) ................................................4-25
Mode Menu (MODE) ..........................................................................................4-25
Setting the Fixture Type (TYPE) ....................................................................4-25
Setting the User Type (USER) .......................................................................4-26
Copying User Presets (PRST) ........................................................................4-27
Copying User Settings (SETT) .......................................................................4-27
Copying User Presets and Settings (ALL) .....................................................4-28
Crossloading Fixture Software (XLD) ...........................................................4-28
Test Menu (TEST) ................................................................................................4-29
Homing the Fixture (HOME) ........................................................................4-30
Turning the Lamp On or Off (LAMP) ...........................................................4-30
Copying the Boot Code (BOOT) ...................................................................4-31
Performing Self Tests (SELF) ........................................................................4-31
Placing the Fixture in Setup Mode (S/UP) ....................................................4-32
Testing the LED Display (DISP) ....................................................................4-33
Information Menu (INFO) ...................................................................................4-33
Viewing the Current Logic Board Temperature (PCB) ................................4-33
Viewing the Current Fixture Head Temperature (HEAD) ...........................4-34
Viewing the Current Lamp Hours (L/HR) ....................................................4-34
Viewing the Current Fixture Hours (F/HR) ..................................................4-34
Viewing the Number of Current Lamp Strikes (L/ST) ..................................4-35
Viewing the Current Software Version (VER) ..............................................4-35
Viewing DMX Status and Construct Values (FIXT) ......................................4-35
Viewing DMX Data for Another Device (DATA) .........................................4-37
Viewing Sensor Information (SENS) ............................................................4-38
Resetting Fixture Hours (F/RS) .....................................................................4-38
Resetting Lamp Hours (L/RS) .......................................................................4-39
Preset Menu (PRST) ............................................................................................4-39
Setting Preset Playback (PLAY) .....................................................................4-39
Editing an On-Board Memory Scene (EDIT) ...............................................4-40
Copying an On-Board Memory Scene (COPY) ............................................4-41
Capturing a Preset Scene (CAPT) .................................................................4-41