15"
www.EJF.com"
FAN MOUNTING CONTINUED
PICTURE ON LEFT: Sand the inside of the fuselage where the Fan mount will need to be glued to the fuselage, then
clean all dust to have it ready for the glue.
PICTURE ON RIGHT: Test fit the fan mount to the fuselage and make sure it does not touch any part of the intake, you
can at this time also check the fan you are going to use. Once satisfied with the fit, Glue the fan mount to the fuselage.
PICTURE ABOVE: The other two formers make up the front tray.
To Next Page
Loading...
