EasyManua.ls Logo

HIGH ONE 10S49 E W701T - Loading Your Dishwasher

HIGH ONE 10S49 E W701T
75 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32 33
EN EN
Useful information Useful information
C C
Spray arms
Make sure that the spray holes are not clogged and that no food waste or foreign object is
stuck to the spray arms. If there is any clogging,remove the spray arms and clean them
under water. To remove the upper spray arm undo the nut holding it in position by turning
it clockwise and pulling it downwards. Make sure that the nut is properly tightened when
refitting the upperspray arm.
Drain Pump
Large food residues or foreign objects which were not captured by the filters may block the
waste water pump. The rinsing water will then be above the filter.
WARNING RISK OF CUTS!
When cleaning the waste water pump, ensure that you do
not injure yourself on pieces of broken glass or pointed
implements.
In this case:
1. First always disconnect the appliance from the power supply.
2. Take out baskets.
3. Remove the filters.
4. Scoop out water, use a sponge if required.
5. Check the area and remove any foreign objects.
6. Install filters.
7. Re-insert baskets.
Troubleshooting
Fault Possible cause Troubleshooting
The programme does not
start.
Your Dishwasher is not
plugged in.
Plug your Dishwasher in.
Your Dishwasher is not
switched on.
Switch your Dishwasher
on by pressing the On/Off
button.
Fuse blown. Check your indoor fuses.
Water inlet tap is closed. Turn on the water inlet tap.
Your Dishwasher door is
open.
Close the Dishwasher door.
Water inlet hose and
machine filters are clogged.
Check the water inlet hose
and machine filters and
make sure they are not
clogged.
Water remains inside the
machine.
Water drain hose is clogged
or twisted.
Check the drain hose, then
either clean or untwist it.
The filters are clogged. Clean the filters.
The programme is not
finished yet.
Wait until the programme is
finished.
Machine stops during
washing.
Power failure. Check mains power.
Water inlet failure. Check water tap.
Shaking and hitting noises
are heard during a wash
operation.
The spray arm is hitting the
dishes in the lower basket.
Move or remove items
blocking the spray arm.