36 37
EN EN
Useful information Useful information
C C
Automatic fault warnings and what to do
TROUBLE CODE
POSSIBLE
FAULT
WHAT TO DO
Start /
Pause
Wash Dry End
*Water inlet
system failure
Make sure the water inlet tap is open
and water is flowing.
Separate the inlet hose from the tap
and clean the filter of the hose.
Contact for service if the error
continues.
Pressure system
failure
Contact for service.
Continuous water
input
Close the tap and contact for service.
Inability to
discharge water
Water discharge hose and filters may
be clogged.
Cancel the programme.
If the error continues, contact for
service.
Contact for service.
Faulty heater and
heater sensor
Contact for service.
Overflow
Unplug the machine and close the tap.
Contact for service.
Faulty electronic
card
Contact for service.
Overheating Contact for service.
Unsuccessful
heating
Contact for service.
Hihg voltage Contact for service.
Low voltage Contact for service.
NOTE:
The led showing water inlet system failure varies depending
on the model.
The installation and repairing procedures should always carried out by the Authorised Service
Agent in order to avoid possible risks. The manufacturer shall not be held liable for damages
that may arise from procedures carried out by unauthorised persons. Repairs may be carried
out by technicians only. If a component has to be replaced, ensure that only original spare
parts are used.
Improper repairs or use of non-original spare parts may cause considerable damage and put
the user at considerable risk.
Contact information for your customer service can be found on the back of this document.
Function-relevant genuine spare parts according to the corresponding Ecodesign order can
be obtained from Customer Service for a period of at least 10 years from the date on which
your appliance was placed on the market within the European Economic Area.
To Next Page
Loading...