12 13
EN EN
Using the appliance Using the appliance
B B
Fill the salt (IF AVAILABLE)
To add softener salt, open the salt compartment cap by turning it counter clockwise.
1
2
At first use, fill the compartment with 1 kg salt and water
3
until it is almost overflowing. If
available, using a funnel
4
will make filling easier. Replace the cap and close it. After every
20-30 Cycles add salt into your machine until it fills up (approx. 1 kg).
1 2
3 4
SALT
Only add water to the salt compartment on first use.
• Use softener salt specifically produced for use in dishwashers.
• When you start your dishwasher, the salt compartment is filled with water, therefore put the
softener salt in prior to starting your machine.
• If the softener salt has overflowed and you do not start the machine immediately, run a short
washing program to protect your machine against corrosion.
Test Strip
Run water
through the
tap (1min.)
Keep the
strip in the
water (1sec)
Shake the
strip.
Wait (1min.)
Set the
hardness
level of your
machine.
1
munite
1
second
1
munite
NOTE
The level is set to 3 as default. If the water is well water or
has a hardness level above 90 dF, we recommend that you
use filter and refinement devices.
Water Hardness Table
Level German dH French dF British dE Indicator
1 0-5 0-9 0-6 Wash LED is on.
2 6-11 10-20 7-14 Dry LED is on.
3 12-17 21-30 15-21 End button is on.
4 18-22 31-40 22-28 Wash and Dry LEDs are on.
5 23-34 41-60 29-42 Wash and End LEDs are on.
6 35-50 61-90 43-63 Dry and End LEDs are on.
Water Softener System
The dishwasher is equipped with a water softener which reduces the hardness in the mains
water supply. To find out the hardness level of your tap water, contact your water company or
use the test strip (if available).
To Next Page
Loading...