Step 4 Configure the System to Mount Volumes at Startup
Instruct the system to automatically mount the array by modifying the file /etc/fstab.
Example: Add the following line to instruct the system to mount /dev/da1s1e to
location /mnt/hpt after startup:
/dev/da1s1e /mnt/hpt ufs rw 0 0
3 - Updating the Driver
To update the driver with a newer revision, simply reinstall the driver following the
steps discussed in the previous section, “Install the driver on an existing system”.
4 – Uninstalling the Driver
The driver can only be uninstalled when the system is not booting from devices
attached to the RocketRAID 174x controller. To uninstall, remove the line
rr174x_load=”YES” located in /boot/defaults/loader.conf, and then delete the driver
module /modules/rr174x.ko or /boot/kernel/rr174x.ko.
6-7
FreeBSD Driver Support
To Next Page
Loading...
