RocketRAID 37xx/8xx/28xx Uniontech OS Server 20 Installation Guide
- 6 -
press “CRL+ALT+F2” to switch console 2 and type the following commands:
sh /tmp/hptdd/postinst.sh /dev/sdb
Press “Ctrl+ALT+F7” to switch back to installation screen and finish the
installation.
3 Installing RR3740A driver on an Existing System
Note
If you use a SCSI adapter to boot your system, you must make sure the RR3740A
controller EFI will be loaded after that adapter’s EFI. If not, try to move it to another PCI
slot. Otherwise you may be unable to boot up your system.
To Next Page
Loading...
