Thermal Monocular User Manual
15
switching on the camera.
–
External: Cover the lens cover, then hold in the live view to correct the non-
uniformity of display.
5. Hold to save the settings and exit.
Note
The countdown will start before the device performs FFC automatically.
3.12 Correct Defective Pixel
The device can correct the defective pixels on the screen which are not performed as
expected.
Steps
1. Hold to show the menu.
2. Go to Advanced Settings, and select Function Settings.
3. Press or to select , and press to enter DPC configuration interface.
4. Press to select X or Y Axis. If you select X axis, the cursor moves left and right; if
you select Y axis, the cursor moves up and down.
5. Press or to set the coordinates until the cursor reaches the defective pixel.
6. Press twice to correct the dead pixel.
7. Hold to save the settings and exit.
Note
●
The selected defective pixel can be magnified and displayed on the bottom right of the
interface.
Figure 3-6 Correct Defective Pixel
●
If the screen OSD blocks the defective pixel, move the cursor to reach the defective
To Next Page
Loading...
