HIKOKI CC 14ST - Transport, Maintenance, and Information; Transport and Maintenance; Technical and Supply Information

English
10
Information concerning airborne noise and vibration
The measured values were determined according to
EN62841.
The typical A-weighted sound pressure level: 95 dB (A).
The typical A-weighied sound power level: 108 dB (A).
Wear hearing protection.
● Information about power supply system of nominal
voltage 230 V~
Under unfavorable mains conditions, this power tool
may cause transient voltage drops or interfering voltage
fl uctuations.
This power tool is intended for the connection to a power
supply system with a maximum permissible system
impedance Z
MAX of 0.14 Ohm at the interface point (power
service box) of the user’s supply.
The user has to ensure that this power tool is connected
only to a power supply system which fulfi lls the requirement
above.
If necessary, the user can ask the public power supply
company for the system impedance at the interface point.
● Information about power supply system of nominal
voltage 230 V~
This tool should be used only if it is connected to a 16 A
Fuse with gl disconnection characteristic.
8. Transporting the unit (Fig.13)
When moving the unit, attach the chain hook onto the
chain and grip the carrying handle to carry it.
MAINTENANCE AND INSPECTION
CAUTION
Be sure to switch off and pull off the plug from the power
outlet before inspection and maintenance.
1. Replacing a cut-off wheel
When the cut-off wheel has already become dull while
continually using, the unnecessary load is got from the
motor. Consequently, redress or replace a dull cut-off
wheel to ensure grinding effi ciency.
2. Inspecting the carbon brushes (Fig. 14)
The Motor employs carbon brushes which are
consumable parts. Since an excessive worn carbon
brush can result in motor trouble, replace both carbon
brushes with new ones shown in the fi gure when it
becomes worn to or near the "wear limit". In addition,
always keep carbon brushes clean and ensure that they
slide freely within the brush holders.
3. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
4. Replacing supply cord
If the replacement of the supply cord is necessary, it has
to be done by HiKOKI Authorized Service Center to avoid
a safety hazard.
5. Lubrication
Supply oil in the following oil supply points once a month
so as to keep the machine workable for a long time.
Oil supply points.
○ Rotary part of shaft
○ Rotary part of vise
○ Slide way of vise (A)
6. Cleaning
Wipe off chip and waste adhered to the machine with a
cloth or the like time to time. Be careful not to make the
motor portion wet with oil or water.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
GUARANTEE
We guarantee HiKOKI Power Tools in accordance with
statutory/country specifi c regulation. This guarantee does
not cover defects or damage due to misuse, abuse, or normal
wear and tear. In case of complaint, please send the Power
Tool, undismantled, with the GUARANTEE CERTIFICATE
found at the end of this Handling instruction, to a HiKOKI
Authorized Service Center.
NOTE
Due to HiKOKI’s continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
000BookCC14STTurUkRu.indb10000BookCC14STTurUkRu.indb10 2019/01/219:54:502019/01/219:54:50