HIKOKI SP 18VA - Operating Instructions; Before Start-Up; Switching the Power Tool on and off; Use of an Extraction System

4. Operating instructions
4.1 Before start-up
- Unpack the power tool and accessories and check that the delivery is complete and that there is no possible transport damage.
- Check: Alignment of the machine - the level should be in balance.
- Check: Firm seating of the milling plate on the drive spindle.
- Check: Position of the speed preselection switch: max. position level 2
4.2 Switching the power tool on and off
Short-time operation without latching:
- Press and hold the switch.
- Release the switch to switch off.
Continuous operation with engagement:
- Push the switch upwards and press the latching button on the handle.
Switch off the unit:
- Press switch upwards; latching button unlocks, release switch
4.3 Use of an extraction system
When using the floor machine SP18 VA, connect a class M hoover.
- Attach the suction hose to the connection piece.
- Connect the suction hose to the suction system. Observe the operating instructions of the extraction system! Check the attachment! If
necessary, use a suitable adapter.
4.4 Working with the power tool
1. fix the milling plate.
2. Check the level: Is the machine level with the surface? Readjustment may be
necessary
3. Connect the suction system.
4. Plug in the mains plug.
5. Carry out a test run to check that the tool is correctly attached.
6. Set the required speed. (max. speed 2)
7. Switch on the extraction system.
8. Always hold the power tool with both hands. Always keep one hand on the
one hand on the power tool so that it can be switched off immediately in an emergency.
9. Switch on the power tool.
10. Operate the pole machine with overlapping, circular or oval movements.
11. When driving along walls, keep a safety distance of at least 5 mm.
4.5 After work
- Switch off the power tool and pull out the mains plug.
- Switch off the extraction system.
- Clean the power tool.
5. Maintenance and care
- Blow out the interior of the housing with the motor regularly with dry compressed air.
- Clean the protective cover with dry compressed air. Remove stubborn deposits with a brush.
- Remove the milling disc from the machine after each use and clean it with warm water, a brush or a paintbrush.
- Have repairs carried out exclusively by a customer service workshop authorised by the manufacturer.
6. Disposal instructions
Only for EU countries
Do not throw power tools in the household waste! According to the European Directive 2012/19/EU on waste electrical and electronic
equipment and its implementation in national law, used power tools must be collected separately and recycled in an environmentally
sound manner.
7. Disclaimer
The manufacturer and its representative are not liable for damage and loss of profit due to interruption of business caused by the
product or the inability to use the product. The manufacturer and its representative are not liable for damage caused by improper use or
in connection with products of other manufacturers.
4