HIKVISION AX PRO Manual

5
Funcons
Formang
7
6
Set up with App
8
Operaon Cauon and Device Maintenance
- All the electronic operaon should be strictly compliance with the electrical safety regulaons, fire prevenon regulaons and other related
regulaons in your local region.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnesm radiaon. Avoid the equipment
installaon on vibraons surface or places subject to shock (ignorance can cause equipment damage).
- Please make sure that the power has been disconnected before you wire, install or dismantle the device.
- If smoke, odors or noise rise from the device, turn off the power at once and unplug the power cable, and then please contact the service
center.
- Do not drop the device or subject it to physical shock, and do not expose it to high electromagnesm radiaon. Avoid the equipment
installaon on vibraons surface or places subject to shock (ignorance can cause equipment damage).
- Do not place the device in extremely hot (refer to the specificaon of the device for the detailed operaon temperature), cold, dusty or
damp locaons, and do not expose it to high electromagnec radiaon.
- The device for indoor use shall be kept from rain and moisture.
Exposing the equipment to direct sun light, low venlaon or heat source such as heater or radiator is forbidden (ignorance can cause fire
danger).
- Do not aim the device at the sun or extra bright places. A blooming or smear may occur otherwise (which is not a malfuncon however), and
affecng the endurance of sensor at the same me.
- Improper use or replacement of the baery may result in hazard of explosion. Replace with the same or equivalent type only. Dispose of
used baeries according to the instrucons provided by the baery manufacturer.
- Do not expose the device to the corrosive gas. Otherwise the equipment damage may occur.
- Do not expose the device to the explosive situaon.
Funcon Descripon
Panic Alarm Press the buon to trigger the alarm while in emergency condion. The LED keeps red for 2 s.
Medical Alarm
Set the panic buon as medical buon via the AX PRO client. Press the buon to trigger the
alarm while in emergency condion. The LED keeps red for 2 s.
Panic Alarm
Press the two buons synchronously to trigger the alarm while in emergency condion. The LED
keeps red for 2 s.
Medical Al
arm
Set the panic buon as medical buon via the AX PRO client. Press the two buons
synchronously to trigger the alarm while in emergency condion. The LED keeps red for 2 s.
3
Hangzhou Hikvision Digital Technology CO.,Ltd. No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
Funcon
Zone Type
Enable Silent Zone
Slide to green to make the zone keep
silent while alarm is triggered.
Select the zone type of the detector.
Descripon
You can view the device status including temperature, signal intensity,baery level, connecon, 24-hour zone, and operaon mode on the device page.
Tap the buon to enter the sengs page.
Cross Zone
Link Camera
If the alarm triggered in both of the linked zones within
the set me, two alarm messages will be reported.
Polling Rate
Set the interval of heartbeat.
Link with a camera for intruder verificaon.
Accidental Press Protecon
Set the protecon mode to prevent
from false alarm.
Remove the baery. Hold any buon for 8 seconds and meanwhile put the baery in . The red LED flashes 3 mes when the format-
ng is completed.

HIKVISION AX PRO Specifications

General

Brand	HIKVISION
Model	AX PRO
Category	Security System
Language	English