DS-1002KI front panel introduction
Fig 2
Key button function introduction
Button name Function introduction
ESC back to up-level menu
Setup hold for 3 seconds, enter into keyboard configuration state (default password: 8888)
Search press 1 second, check keyboard Configuration: the PTZ protocol
Shift switch the control mode of embedded DVR or speed dome
PRESET In PTZ control mode: setup the speed dome preset position.
DEL In PTZ control mode: clear the speed dome preset position.
In PTZ control mode: call PTZ preset SHOT
(REC)
In DVR control mode: enter into DVR manual recording menu
F1 Quick key-press of setup speed dome, it is related to used protocol, refer to LCD
explanation.
In PTZ control mode: set the speed dome to auto rotate（depend on speed dome
itself, please reference the speed dome’s manual）
Auto
(PLAY)
In DVR control mode: enter into DVR playback menu
F2 Quick key-press of setup speed dome, it is related to used protocol, refer to LCD
explanation
Addr choose addresses of PTZ or the device ID of embedded DVRs
Clear clean currently input content
ENTER confirm currently input content
Number: 0, 1, 2, 3, 4, 5, 6, 7, 8, 9 0-9
Letter
A-Z (26 letters)
In PTZ control mode: set the lens focus near FOCUS+
(A)
In DVR control mode: switch input method
In PTZ control mode: set the lens focus far FOCUS-
(PREV)
In DVR control mode: switch DVR preview mode
ZOOM+ In PTZ control mode: zoom in the lens
6
To Next Page
Loading...
